If SD card format failure is not related to write protection, you can consider whether it is caused by bad sector. Here are the detailed steps. Step 1. Install and launch the software. In the home interface, right-click the SD card partition and choose Format Partition. Step 2. Choose a proper file system and click OK. You can also add partition label or adjust cluster size of this partition if you like. Step 3. Back to the main interface, you can click Apply and Proceed to execute the operation.
If the SD card is infected by virus, it will unable to be accessed by other programs. At this point, you can run third-party anti-virus software to fully scan the SD card, thus you can know whether it is infected. If your SD card will not format in Windows 10, 8, 8. How can you format it in File Explorer when you are unable to find out it? Since you have realized the possible factors of SanDisk not formatting, you can predict the specific reasons and take responding solutions listed below:.
If you want to format it, you can remove the write protection. Some card readers might be with a physical switch that can be used to lock write protection. The steps are listed as follows:. Then, you can try to format SD card again. Here are the detailed steps:. In such a case, you can format it or create new partition via Disk Management. I have deleted everything on there and tried restarting my computer but as of yet, I am unable to reformat the SD card. I know that the issue is not with the phone because I put in a smaller SD card and it seems to be working as usual.
I know I could just buy another one, but I would really rather get this one working after putting all this time and effort into it. Would love to hear any possible suggestions to this issue. Was this reply helpful? Yes No. Sorry this didn't help. Thanks for your feedback. Thank you for your fast response. I forgot to mention, I tried to clean it with disk part and it said that it was successful but when I looked at the folder there was still data inside.
My adapter has that switch on it, but I checked it both ways and I am currently in the unlocked mode. But then, once I click close, another window opens see photo before last that says repair this drive, and every time I go through it, it just continues the pattern, so I'm not sure what this means.
Hello everyone, After scrounging the internet for the past two days and trying what I feel is almost everything I wanted to come here to ask for help. I try to format it on Windows but it says, "Windows was unable to complete the format" I try to format it with disk management and it says " The format did not complete successfully " I run the chkdsk, which returns with this result: The volume has been successfully checked, but Windows was unable to mark the volume as clean.
Windows has scanned the file system and found no problems. No further action is required.
0コメント